Minidisc mds je480 manual

Reviewed Nov 18th, by ArturV. My unit is from April and it works flawlessly since. I have done full service to it twice in 22 years and still is pretty much enjoyable.

I currently use it to make some playlists, is my favourite music format! Reviewed Dec 16th, by sisse. Reviewed Jun 22nd, by genbpo. A cheap but good MD deck. Using it since and it still didnt't need any service. And it sounded pretty good, especially after replacing some of the capacitors.

Reviewed Sep 08th, by apollosix. Have owned this unit since new. If the MD has been partially recorded, recording starts after the recorded tracks. Each time you press the button, the display Turn on the amplifier and program changes cyclically as follows: source, and select the source on the Therefore, if the output level of the connected You can adjust the recording level for both component is low, it may not be possible to set the analog and digital recordings.

Do this Stop play Press x. See this page for details. This happens when you have point of the portion to be erased point edited the same track many times. Note that new After track has no name.

Page 22 Naming a track or an MD continued If you have selected numbers Press the corresponding number button. Repeat steps 4 to 6 to enter the rest of The number is entered and the cursor shifts the name.

Page Other Functions Other Functions Falling asleep to music Fading in and fading out — Sleep Timer Fade-in Recording gradually increases the You can set the deck so that it turns off signal level at the start of recording.

Fade-out automatically after a specified duration. Recording gradually decreases the signal level at the end of recording. Page Additional Information MD. Page Guide To The Serial Copy Management System Guide to the Serial Copy The remaining recording time does not increase even after erasing Management System numerous short tracks Digital audio components, such as CDs, MDs, Tracks under 12 seconds in length are not and DATs, make it easy to produce high-quality counted and so erasing them may not lead to an copies of music by processing music as a digital increase in the recording time.

Page Troubleshooting MD out and leave the deck in a warm place for indicated countermeasure. Published by Sony Techno Create Corporation. Laser diode. Connector type: square optical Impedance: nm optical wave length. Jack type: phono Rated output: 2 Vrms at 50 kilohms Load impedance: over 10 kilohms. Design and specifications are subject to change without notice. Check leakage as described below. The AC leakage from any exposed metal part to earth ground and from all exposed metal parts to any exposed metal part having a return to chassis, must not exceed 0.

Leakage current can be measured by any one of three methods. A commercial leakage tester, such as the Simpson or RCA. A battery-operated AC milliammeter. The Data Precision Measuring the voltage drop across a resistor by means of a VOM. Nearly all battery operated digital multimeters that have a 2V AC range are suitable.

See Fig. Using an AC voltmeter to check AC leakage. To Exposed Metal Parts on Set. AC voltmeter 0. Laser component in this product is capable of emitting radiation exceeding the limit for Class 1. CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radia- tion exposure.

The laser diode in the optical pick-up block may suffer electrostatic break-down because of the potential difference generated by the charged electrostatic load, etc. During repair, pay attention to electrostatic break-down and also use the procedure in the printed matter which is included in the repair parts.

The flexible board is easily damaged and should be handled with care. Never look into the laser diode emission from right above when checking it for adjustment.