Ms2687b manual

In-Stock Notification Request Sent Your request to be notified when this product is back in stock has been sent to our sales department.

We will notify you as soon as this item is available for purchase. Thank you for allowing us the opportunity to assist with your test equipment needs. We hope to earn your business. Close Wizard. Error Sending Request We are very sorry but an error on the server is preventing your request from being processed. Please contact us via email or toll free at and we will be happy to assist you with this request.

We would also greatly appreciate it if you could provide us with this error code: Close Wizard. Unable to Process Request Your offer was received but we are unable to process it for the following reason:???

Please correct the issue indicated and resubmit or contact us via email or toll free at and we will be happy to assist you with this request. Correct Issue Close Wizard. Offer AccuSource Electronics is always happy to consider reasonable offers on our test instruments.

Option Range expansion power meter function retrofit Option Range expansion power meter function upgrade Option Auto power recovery. Option Extended three year warranty service Option Extended five year warranty service.

Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up. Forgot password? Enter your email address and check your inbox. Please check your email for further instructions.

There -is- a way to enable maintenance mode via a different mechanism likely pressing a magic key combination? After that, enter the configuration press "Config" , and then press "System".

Without maintenance mode enabled first, you'd now be able to chose the "system" i. I was able to enable option "Narrow Resolution Bandwidth" aka.

FFT mode , and "Ethernet". I tried switching option "Auto Power Recovery", i. Some options are set to not be disabled "NOf", "NOn". Interestingly not all options have an entry , but you can just add them. I've tried adding Opt 21 "power meter" for Spectrum Analyzer; from MSA datasheet , and while it made me able to start the Power Meter, it's non-functioning. It's probably a different hardware option than the TX tester power sensor, unfortunately, or the calibration is way off.

Make sure you capture your set of enabled options first! Not sure if it's possible to backup the internal state to a CF card first. I've tested this on version 4. If someone has another version I know Wuerstchenhund had one showing 4. Have fun! The following users thanked this post: Mechatrommer , brainstorm , little. Oh, indeed! Holding "0" at startup - the device will beep before switching on the screen - will also enable maintenance mode!

Curious - is this documented?